CHAPTER 17
Maintaining the SRX210 Services Gateway
Hardware Components
This chapter describes how to maintain the hardware components of the SRX210 Services
Gateway. This chapter includes the following topic:
•
Maintaining the SRX210 Services Gateway Hardware Components on page 111
Maintaining the SRX210 Services Gateway Hardware Components
Table 41 on page 111 describes the common tasks for maintaining the hardware
components of the services gateway.
Table 41: Maintenance Procedures for Services Gateway Hardware
Components
Description
Maintenance
Procedures
To maintain optimum performance of the services gateway, you should
regularly perform the following preventive maintenance procedures:
•
Inspect the installation site for moisture, loose wires or cables, and
excessive dust.
•
Make sure that airflow is unobstructed around the device and into the
air intake vents.
•
Check the Status LED on the front panel of the device and on the
Mini-Physical Interface Module (Mini-PIM) that you are using.
Routine
Maintenance
The services gateway cooling system works to maintain an optimal
temperature for the device. If the fan controller fails, the device temperature
will exceed the maximum working temperature, and the device will fail.
Ensure that you maintain the recommended clearances behind the device
to enable the cooling system to function optimally.
Maintaining the
cooling system
111Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...
