6. From the management device, open a Web browser and enter the IP address 192.168.1.1
in the address field if the management device is configured using the DHCP.
7. Configure basic settings for your services gateway.
NOTE: You must manually configure the IP address for the management
port you are using before you save your initial configuration. When you
save the configuration for the first time, you will lose the connection to
the services gateway if you have not manually configured the IP address.
If you lose the connection through the management interface, you must
connect through the console port.
Related
Documentation
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface on page 103
•
• Connecting an SRX210 Services Gateway to the CLI Locally on page 91
• SRX210 Services Gateway Software Configuration Overview on page 97
• SRX210 Services Gateway Secure Web Access Overview on page 106
Connecting an SRX210 Services Gateway to the CLI Locally
If you plan to use the CLI to configure the SRX210 Services Gateway, you must connect
through the console port, as shown in Figure 28 on page 91.
Figure 28: Connecting to the Console Port on an SRX210 Services Gateway
91Copyright © 2010, Juniper Networks, Inc.
Chapter 15: Connecting the SRX210 Services Gateway to Management Devices
To Next Page
Loading...
