CHAPTER 15
Connecting the SRX210 Services Gateway
to Management Devices
This chapter includes the following topics:
•
Connecting an SRX210 Services Gateway to the J-Web Interface on page 89
•
Connecting an SRX210 Services Gateway to the CLI Locally on page 91
•
Connecting an SRX210 Services Gateway to the CLI Remotely on page 93
•
Connecting the Modem at the SRX210 Services Gateway End on page 93
•
Connecting the Modem to the Console Port on the SRX210 Services Gateway on page 94
•
Connecting to the CLI at the User End for the SRX210 Services Gateway on page 95
Connecting an SRX210 Services Gateway to the J-Web Interface
If you plan to use the J-Web interface to configure the SRX210 Services Gateway, you
must connect through one of the built-in Ethernet management ports.
When the services gateway is powered on for the first time, the system looks for a DHCP
server. If it does not find one, the system assigns an IP address within the 192.168.1.0/24
subnetwork to any devices connected to the system.
To connect to the J-Web interface through any of the ports ge-0/0/1 or fe-0/0/2 to
fe-0/0/7 on the services gateway, see Figure 27 on page 90.
89Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...
