Juniper SRX210 - HARDWARE GUIDE REV 3 - Preparing the SRX210 Services Gateway for Desk-Mount Installation

• Preparing the SRX210 Services Gateway for Wall-Mount Installation on page 68
Preparing the SRX210 Services Gateway for Desk-Mount Installation
You can mount an SRX210 Services Gateway on a desk or other level surface horizontally
or vertically. The four rubber feet attached to the chassis provide stability.
Table 29 on page 67 provides the list of tasks you need to perform before installing the
device.
Table 29: SRX210 Services Gateway Preinstallation Checklist for
Desk-Mount Installation
Additional InformationTask
“Site Preparation Checklist for the SRX210
Services Gateway” on page 49
Verify that the site meets the requirements.
“Clearance Requirements for Airflow and
Hardware Maintenance of the SRX210
Services Gateway” on page 53
Place the desk in its permanent location, allowing
adequate clearance for airflow and maintenance,
and secure it to the building structure.
“Unpacking the SRX210 Services Gateway”
on page 61
Remove the services gateway chassis from the
shipping carton.
Verify that you have the following parts available in
your desk-mounting kit to mount the SRX210
Services Gateway vertically:
•
Vertical stand
•
Screws
NOTE: If you are mounting the services gateway horizontally on a desk, verify
that the rubber feet are attached to the chassis.
NOTE: The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Related
Documentation
Site Preparation Checklist for the SRX210 Services Gateway on page 49•
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX210 Services
Gateway on page 53
• Unpacking the SRX210 Services Gateway on page 61
• Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 65
• Preparing the SRX210 Services Gateway for Wall-Mount Installation on page 68
67Copyright © 2010, Juniper Networks, Inc.
Chapter 11: Preparing the SRX210 Services Gateway for Installation