Juniper SRX210 - HARDWARE GUIDE REV 3 - Monitoring the SRX210 Services Gateway Components Using Leds

Temp CPU Utilization (%) Memory Utilization (%)
Slot State (C) Total Interrupt DRAM (MB) Heap Buffer
0 Online -------------------- CPU less FPC --------------------
1 Online -------------------- CPU less FPC --------------------
show chassis alarms
user@host > show chassis alarms
Alarm time Class Description
2009-05-11 10:47:47 UTC Major SRX210 Chassis Fan Failure
Related
Documentation
Monitoring the SRX210 Services Gateway Components Using LEDs on page 115•
• Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 118
• Monitoring the SRX210 Services Gateway Power System on page 119
• Maintaining the SRX210 Services Gateway Hardware Components on page 111
• Juniper Networks Technical Assistance Center on page 122
Monitoring the SRX210 Services Gateway Components Using LEDs
Table 42: Component LEDs on the Services Gateway
Possible Causes and
Corrective ActionsMeaningStateLED
Normal condition. No action
is required.
Indicates that the device is
functioning normally.
GreenStatus LED
Normal condition. No action
is required.
•
The device is starting up.
•
The Reset Config button
is pressed.
Amber
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See “Juniper Networks
Technical Assistance
Center” on page 122.
An error is detected in the
device.
Red
115Copyright © 2010, Juniper Networks, Inc.
Chapter 18: Monitoring the SRX210 Services Gateway