CHAPTER 8
Installation Overview for the SRX210
Services Gateway
This chapter includes the following topic:
•
Installation Overview for the SRX210 Services Gateway on page 57
Installation Overview for the SRX210 Services Gateway
After you have prepared your installation site, you are ready to unpack and install the
services gateway. It is important to proceed through the installation process as shown
in Table 24 on page 57.
Table 24: Installation Process Order for the SRX210 Services Gateway
For more information, seeTaskStep
“SRX210 Services Gateway General
Safety Guidelines and Warnings” on
page 127
Review the safety guidelines
explained.
1
“Site Preparation Checklist for the
SRX210 Services Gateway” on
page 49
Verify that you have prepared your
site for the installation of the services
gateway using the checklist.
2
“Unpacking the SRX210 Services
Gateway” on page 61
Unpack the services gateway and
verify that the parts are received.
3
“Preparing the SRX210 Services
Gateway for Rack-Mount,
Desk-Mount, and Wall-Mount
Installation” on page 65
Prepare the services gateway for
installation.
4
•
Installing the SRX210 Services
Gateway in a Rack on page 71
•
Installing the SRX210 Services
Gateway on a Desk on page 74
•
Installing the SRX210 Services
Gateway on a Wall on page 76
Install the services gateway.5
57Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...
