Juniper SRX210 - HARDWARE GUIDE REV 3 - RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port

Table 50: RJ-45 Connector Pinouts for the Services Gateway Ethernet
Port (1 Gbps) (continued)
SignalPin
BI_DB-6
BI_DD+7
BI_DD-8
Related
Documentation
Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 155•
• RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port on page 157
• SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 10
RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port
Figure 31 on page 157 shows the RJ-45 connector pinouts for the console port.
Figure 31: Console Cable Connector
Table 51 on page 157 describes the RJ-45 connector pinouts for the console port.
Table 51: RJ-45 Connector Pinouts for the Services Gateway Console
Port
DescriptionSignalPin
Request to SendRTS1
Data Terminal ReadyDTR2
Transmit DataTXD3
Signal GroundGround4
Signal GroundGround5
Receive DataRXD6
Data Set ReadyDSR/DCD7
Clear to SendCTS8
157Copyright © 2010, Juniper Networks, Inc.
Appendix C: SRX210 Services Gateway Interface Cable Specifications and Connector Pinouts