Juniper SRX210 - HARDWARE GUIDE REV 3 - Connector Pinouts for the SRX210 Services Gateway with Integrated Convergence Services FXO and FXS Ports

Related
Documentation
Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 155•
• RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port on page 156
• SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 10
RJ-11 Connector Pinouts for the SRX210 Services Gateway with Integrated Convergence
Services FXO and FXS Ports
The FXO and FXS ports use an RJ-11 cable.
Table 52 on page 158 describes the RJ-11 connector pinouts.
Table 52: RJ-11 Connector Pinouts
SignalPin
No connect1
No connect2
RJ P –Ring3
RJ N –Tip4
No connect5
No connect6
Related
Documentation
• Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 155
• RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port on page 156
• RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port on page 157
• SRX210 Services Gateway with Integrated Convergence Services Front Panel and Back
Panel Views on page 12
Copyright © 2010, Juniper Networks, Inc.158
SRX210 Services Gateway Hardware Guide