CHAPTER 18
Monitoring the SRX210 Services Gateway
This chapter describes how to monitor the SRX210 Services Gateway hardware
components. If you encounter software problems, or problems with hardware components
not discussed here, contact the Juniper Networks Technical Assistance Center (JTAC).
This chapter includes the following topics:
•
Monitoring Hardware Components on the SRX210 Services Gateway on page 113
•
Resetting the Configuration File When the SRX210 Services Gateway Is
Inaccessible on page 120
•
Juniper Networks Technical Assistance Center on page 122
Monitoring Hardware Components on the SRX210 Services Gateway
This topic includes the following sections:
•
Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 113
•
Monitoring the SRX210 Services Gateway Components Using LEDs on page 115
•
Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 118
•
Monitoring the SRX210 Services Gateway Power System on page 119
Monitoring the SRX210 Services Gateway Chassis Using the CLI
You can monitor alarms to troubleshoot hardware problems on a services gateway. The
chassis properties include the status of active chassis alarms on the device, environment
measurements, and the status of Mini-PIMs on the device.
To view these chassis properties, select Monitor in the J-Web interface, or enter the
following CLI show commands:
•
show chassis hardware
•
show chassis hardware detail
•
show chassis environment
•
show chassis fpc
•
show chassis alarms
Examples:
113Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...
