Table 10: SRX210 Services Gateway Built-In Hardware
Interfaces (continued)
DescriptionSpecificationsInterface Type
The USB ports can be used as
follows:
•
To support a USB storage
device that functions as a
secondary boot device in
case of the internal flash
failure on startup, if the USB
storage device is installed
and configured
NOTE: You must install and
configure the USB storage
device on the USB port to use
it as secondary boot device.
Also, the USB device must
have Junos installed.
•
To provide the USB
interfaces that are used to
communicate with many
types of Juniper supported
USB storage devices.
Contact your Juniper Networks
customer service
representative for more
information.
•
Consist of two ports
•
Function in full speed and
high speed
•
Are compliant with USB
revision 2.0
Universal Serial Bus (USB)
The console port can be used
as follows:
•
To provide the console
interface
•
To function as a
management port to log
into a device directly
•
To configure the device
using the CLI
•
Consists of one port
•
Uses an RJ-45 serial cable
connector
•
Supports the RS-232
(EIA-232) standard
Console
Copyright © 2010, Juniper Networks, Inc.16
SRX210 Services Gateway Hardware Guide
To Next Page
Loading...
