To install the device in a rack:
1. Position a mounting bracket on each side of the chassis as shown in Figure 17 on
page 72.
Figure 17: Installation of SRX210 Services Gateway in a Rack — Positioning
Mounting Brackets
Table 31 on page 72 lists the parts used for installing the SRX210 Services Gateway
on the rack. The numbers in Figure 17 on page 72 correspond to the numbers in Table
31 on page 72.
Table 31: SRX210 Services Gateway Rack Installation Parts
PartNumber
Mounting brackets1
Screws (mounting bracket)2
Power supply adapter tray3
Adapter stopper bracket4
2. Use a number-1 Phillips screwdriver to install the screws that secure the mounting
brackets and power supply adapter tray to the chassis as shown in Figure 18 on page 72.
Figure 18: SRX210 Services Gateway Rack Installation — Securing
Mounting Brackets and Power Supply Adapter Tray
3. Place the power supply adapter in the tray as shown in Figure 19 on page 73.
Copyright © 2010, Juniper Networks, Inc.72
SRX210 Services Gateway Hardware Guide
To Next Page
Loading...
