KCM 70Z7 - Inspection and Maintenance Table

MAINTENANCE
7-13
Inspection and Maintenance Table
Check and/or carry out the maintenance at intervals of
the specified operating hours below or the calender date,
whichever comes first.
IMPORTANT
Severe applications require more frequent
maintenance. Severe conditions include heavy dust,
extremely abrasive material, caustic chemicals,
extremely wet conditions or abnormally hot or cold
ambient temperatures.
U: First time replacement or cleaning only
Section Item for check
Operating hours
Page
10 50 100 250 500 1000 2000 4000 4500
Engine
Check Engine Oil Level
{
7-26
Check Coolant Level
{
7-71
Check Accelerator Pedal Operation, and
Exhaust Gas Color and Noise
{
7-102
Drain Fuel Filter
{
7-62
Check Fuel Level
{
7-59
Check Drive Belt
{
7-72
Check Fuel Hoses
{
7-66
Check Crankcase Breather Tube
{
7-30
Dust Ejection Valve
{
7-68
Check Air Inlet System
{
7-69
Check Drive Belt Tension
{
7-72
Change Engine Oil
{
7-27
Replace Engine Oil Filter
{
7-29
Clean Radiator / Oil cooler Cores and
Other Cooling System
*3
{ 7-74
Drain Water and Sediment from Fuel
Tank
{
7-61
Replace Fuel Main Filter Element
{
7-63
Replace Fuel Pre-Filter Element
{
7-64
Clean Fuel Pump Strainer
{
7-65
Check and Adjust Valve Clearance
{
7-104
Check Sound Absorbing Mat Around
Engine
{
7-104
Replace Crankcase Air Breather Element
{
7-31
Check Vibration Damper
{
7-33
Clean and Replace Air Cleaner Element Indicator comes ON { 7-67
Change Coolant Every 2 years or 3000 hours { 7-73

NOTE:

*3 Shorten maintenance intervals when the machine is operated under severe conditions or
when the machine is continuously operated for a long period of time.