KCM 70Z7 - Page 264

MAINTENANCE
7-23
11. One point each to upper and lower chassis center hinge
pins (14 and 15).
--- every 250 hours
Upper (14)
Lower (15)
12. One point each to front and rear axle support pins (16
and 17).
--- every 10 hours
Front (16)
Rear (17)
13. One point to front propeller shaft universal (18).
--- every 12000 hours

NOTE: When the machine is continuously operated under
severe conditions for a long time, shorten the greasing
intervals.
15
14
18
17 16
M4GB-07-013
MNEC-07-009
M4GB-07-010
MNEC-07-008