SAFETY
S-30
Clean up Flammables:
y Spilled fuel and oil, and trash, grease, debris, accumulated
coal dust, and other flammables may cause fires.
x Prevent fires by inspecting and cleaning the machine
daily, and by removing adhered oil or accumulated
flammables immediately. Check and clean high
temperature parts such as the exhaust outlet and
mufflers earlier than the normal interval.
x Do not wrap high temperature parts such as a muffler or
exhaust pipe with oil absorbents.
x Do not store oily cloths as they are vulnerable to
catching fire.
x Keep flammables away from open flames.
x Do not ignite or crush a pressurized or sealed container.
x Wire screens may be provided on openings on the
engine compartment covers to prevent flammables
such as dead leaves from entering. However,
flammables which have passed through the wire screen
may cause fires. Check and clean the machine every day
and immediately remove accumulated flammables.
The temperature around the engine may tend to
become higher with wire screens. Be careful of the
overheat.
Check Key Switch:
y If a fire breaks out, failure to stop the engine will escalate
the fire, hampering fire fighting.
Always check key switch function before operating the
machine every day:
1. Start the engine and run it at low idle.
2. Turn the key switch to the OFF position to confirm that
the engine stops.
x If any abnormalities are found, be sure to repair them
before operating the machine.
Check Heat Shields:
yDamaged or missing heat shields may lead to fires.
x Damaged or missing heat shields must be repaired or
replaced before operating the machine.
x If hydraulic hoses are broken while the engine cover
is open, splattered oil on the high temperature parts
such as mufflers may cause fire. Always close the engine
cover while operating the machine.
To Next Page
Loading...