2 Front-Panel Menu Operation
44 Keysight 33210A User’s Guide
Configure the parameters for burst.
– Select the triggered (N Cycle) or externally-gated burst mode.
– Select the number of cycles per burst (1 to 50,000, or Infinite).
– Select the starting phase angle of the burst (-360° to +360°).
– Specify the time from the start of one burst to the start of the next burst.
– Specify an internal or external trigger source for the burst.
– Specify the slope (rising or falling edge) for an external trigger source.
– Specify the slope (rising or falling edge) of the “Trig Out” signal.
Store and recall instrument states.
– Store up to four instrument states in non-volatile memory.
– Assign a custom name to each storage location.
– Recall stored instrument states.
– Restore all instrument settings to their factory default values.
– Select the instrument’s power-on configuration (last or factory default).
To Next Page
Loading...
