Appendix
172
On: Changes of the waveform will be applied immediately to the output. The
editor is slower.
Off: The waveform will be applied to output when editing is finished. The
editor is faster due to missing hardware update.
EDIT
Start the point-by-
point editing
process
Press the EDIT softkey to accept the initial waveform settings and begin
point-by-point editing.
The editor is separating the waveform into sections. Each of the sections is
separated by a vertical dashed line and corresponds to one of the bit shapes
that have to be defined. In the upper left corner, the editor is displaying
which bit value transition in the pattern will result in the sub waveform
currently being edited.
Depending on the number of levels, the maximum number of samples in the
waveform varies. With a maximum of 64 samples being used for one bit.
Define the first
waveform point
Press Y softkey to set the voltage level for Point #1 (this point is fixed at
address 0). By default, all points are set to 0.
For this example, set the value of Point # 1 to -8191.
To Next Page
Loading...
