Features and Functions
81150A and 81160A User’s Guide 259
The name can contain up to 12 characters. The first character must
be a letter (A-Z), but the remaining characters can be letters,
numbers (0-9), or the underscore character (“ _ ”). Blank spaces are
not allowed. An error will be generated if you specify a name with
more than 12 characters.
The 81150A / 81160A will not prevent you from assigning the same
custom name to different storage locations. For example, you can
assign the same name to locations “1” and “2”.
If you delete an arbitrary waveform from non-volatile memory after
storing the instrument state, the waveform data is lost and the
81150A / 81160A will not output the waveform when the state is
recalled. The built-in “exponential rise” waveform is output in place
of the deleted waveform.
An instrument reset does not affect the configurations stored in
memory. Once a state is stored, it remains until it is overwritten or
specifically deleted.
Press and then select the Store State or Recall State softkey. To
delete a stored state, select the Delete State softkey (also removes the
custom name for this memory location).
Recall and Delete keys are both disabled if nothing is stored ( and thus
nothing to Recall/Delete exists).
To configure the 81150A / 81160A to recall the factory default state at
power-on, press and then select the Power-ON State softkey. To
configure the 81150A / 81160A to recall the power-down state when power
is restored, press the Power-ON State softkey and select Last Setting.
You can assign a custom name to each of the four storage locations.
The custom name can contain up to 12 characters. The first
character must be a letter but the remaining characters can be
letters, numbers, or the underscore character (“ _ ”).
To add additional characters, press the right-cursor key until the
cursor is to the right of the existing name and then turn the knob.
To delete all characters to the right of the cursor, press the
key.
To Next Page
Loading...
