Appendix
322
[<frequency|DEFault>[,<amplitude>|DEFault> [,<offset>]]]
Output a dc voltage with the level specified by the offset parameter. You can
set the dc voltage to any value between ±5 Vdc into 50 ohms or ±10 Vdc
into an open circuit or depending on the selected amplifier type. The dc
voltage is output as soon as the command is executed.
The frequency and amplitude parameters have no effect for this command
but you must specify a value or “DEFault”.
If you specify a frequency and amplitude, they have no effect on the dc
output, but the values are remembered when you change to a different
function.
To Next Page
Loading...
