Keysight 81150A - Page 557

Remote Programming Reference
81150A and 81160A User’s Guide 557
Command
:DIG:TRAN:INT
Long
:DIGital[1|2][:STIMulus][:PATTern]:TRANsition
:INTerpolate
Parameters
ON|OFF|0|1
Parameter Suffix
-
Description
Use this command to turn interpolation of the bitshape waveform on or off.
When turned off, the output is series of steps from DAC value to DAC value.
When turned on, the output signal is interpolated linearly between adjacent
DAC values.
Example
:DIG:TRAN:INT ON
Interpolation OFF
Interpolation ON