Keysight 81160A - Page 366

Appendix
366
Command
:VOLT[1|2]:LIM[?]
Long
[:SOURCE]:VOLTage[1|2]:LIMit[:HIGH][?]
Parameters
{<NR3>|MINimum|MAXimum}
Parameter Suffix
V
Description
It’s used to set/read the high-level voltage limit. If you switch on voltage
limiting, the high-level voltage cannot be set above the programmed limits.

 The voltage is not limited by the output hardware, it’s a software limit.
 The limits relate to the HIGH and LOW parameters of the instrument.
Example
:VOLT:LIM 2.00