Keysight 81160A - Page 410

Appendix
410
Command
:PWM[1|2]:INT:FREQ[?]
Long
[:SOURCE]:PWM[1|2]:INTernal:FREQuency[:CW|:FIXed]
[?]
Parameters
{<NR3>|MINimum|MAXimum}
Parameter Suffix
HZ
Description
Set the frequency of the modulating waveform. Used only when the Internal
modulation source is selected (PWM[1|2]:SOUR INT command). The :
PWM[1|2]:INT:FREQ? query returns the internal modulating frequency
in Hertz. It does not apply if “INT2” is selected.
Example
:PWM:INT:FREQ 5.5 MHZ