Remote Programming Reference
81150A and 81160A User’s Guide 495
[:SOURce]:SWEep[1|2]:IDLE[?]
{SFRequency|EFRequency|DC}
Specifies the so called sweep ‘idle’ frequency while waiting for a new
trigger event to start a new sweep cycle. If the :swe:idle efr is sent
to the instrument the frequency of the output signal will stay on the stop
(end) frequency of the sweep until a new trigger event occurs.
The idle frequency is the Start FRequency
The idle frequency is the End FRequency (stop
frequency)
The ‘idle frequency’ is a DC level
To Next Page
Loading...
