Keysight E4981A - Page 229

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 229
Initial Settings
Initial Settings, Settings That Can Be Saved/recalled, Settings That Can Be Backed Up
LOAD
correction
ON/OFF OFF No effect OFF × ^
Measurement range ON No effect ON × ^
LOAD
standard
definition
Definition value 100 nF No effect 100 nF × ^
Parameter type CPD No effect CPD × ^
Cable
correction
Correction
data
OPEN - No effect ] ××
LOAD - No effect ] ××
0m standard - No effect ] ××
Correction coefficient clear - No effect ] ××
Correction coefficient calculation and save - No effect ] ××
ON/OFF on correction function - No effect ] × ^
Offset
correction
ON/OFF OFF No effect OFF × ^
Data Setup 0 No effect 0 × ^
Multi
correction
ON/OFF OFF No effect OFF × ^
Channel setup 0 ]]^×
LOAD standard definition method (Single/Multi) OFF No effect OFF × ^
Data transfer
format
Binary/ASCII ASCii ]]^×
Binary Data Byte order NORmal ]]^×
ASCII Long format OFF ]]^×
Data buffer
Feeding target parameter ““ ]]××
Control (feed/not feed) NEVer ]]××
Buffer size
BUF1|BUF2 200 ]]××
BUF3 1000 ]]××
Table C-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Setting items
Initial settings
(factory settings)
Reset
Save/
Recall
Backup
Front panel key
(:SYST:PRES)
*RST