Keysight E4981A - Page 230

230 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Initial Settings
Initial Settings, Settings That Can Be Saved/recalled, Settings That Can Be Backed Up
-
Comparator
ON/OFF OFF ]]^×
Limit range reset No effect ] ××
Limit range
ON/OFF
Primary parameter ON ]]^×
Secondary parameter ON ]]^×
Limit range
setting
Primary limit range setup 0 ]]^×
Secondary limit range setup 0 ]]^×
Primary Limit range
designation method (mode
selection)
ABS ]]^×
Primary Reference (nominal)
value
0 ]]^×
AUX BIN ON/OFF OFF ]]^×
Low C reject
ON/OFF OFF ]]^×
Limit value 0% ]]^×
BIN count
ON/OFF OFF ]]^×
Reset Count value No effect ] ××
Readout of Count value 0 ]]××
Readout of Count value at
overload
- ]]××
Readout of Count value for
each channel
0 ]]××
Readout of Count valueon
overload per channel
- ]]××
Measurement Signal Monitor
1
Current
monitor
ON/OFF ON ]]^×
Monitor
value readout
- No effect ] ××
Voltage
monitor
ON/OFF ON ]]^×
Monitor
value readout
- No effect ] ××
Table C-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Setting items
Initial settings
(factory settings)
Reset
Save/
Recall
Backup
Front panel key
(:SYST:PRES)
*RST