Keysight E4981A - Page 231

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 231
Initial Settings
Initial Settings, Settings That Can Be Saved/recalled, Settings That Can Be Backed Up
Display
ON/OFF ON ]]^×
Fixed point
display
ON/OFF OFF ]]^×
Value of the highest digit (Msd) 1 nF ]]^×
Deviation
measuremen
t mode
Primary
parameter
ON/OFF OFF ]]^×
Mode DEV ]]^×
Secondary
parameter
ON/OFF OFF ]]^×
Mode DEV ]]^×
Reference value 0 ]]^×
Page number of instrument setup display area MEAS ]]^×
Input the comment line ““ ]]^×
Output the displayed image to controller - No effect ] ××
Contact Check ON/OFF OFF ]]^×
Key lock ON/OFF OFF ]]××
Beeper
ON/OFF ON ]]^×
Mode 3 No effect ] × ^
Comparator Beeper condition FAIL ]]^×
Status Report Function
Clear No effect ] ××
Status Byte register value
readout
- No effect ] ××
Service request enable register
value
- No effect ] ××
Standard
event status
register
Register
reading
- No effect ] ××
OPC ON No effect ] ××
Valid register
setup
- No effect ] ××
Operation
event status
register
Clear No effect ] ××
Register
reading
0 No effect ] ××
OPC ON 0 No effect
] ××
Valid register
setup
0 No effect ] ××
Table C-1 Initial settings, settings that can be saved/recalled, settings that can be backed up
Setting items
Initial settings
(factory settings)
Reset
Save/
Recall
Backup
Front panel key
(:SYST:PRES)
*RST