Kikusui PWR401ML - Page 137

PWR-01 137
Appendix ｜ Factory Default Settings
 CONFIG settings
Parame-
ter num-
ber
Description
Description
CF01
1
BLE Sets the bleeder circuit NORM (normal)
CF02 PRIO Output-on startup state CV (CV prioritized)
CF03 VIR Internal resistance setting (VIR) OFF (internal resistance disabled)
CF04 SS.C.R Soft start time (CC mode) 0.0 (soft start disabled)
CF05 SS.C.F Soft stop time (CC mode) 0.0 (soft stop disabled)
CF06 SS.V.R Soft start time (CV mode) 0.0 (soft start disabled)
CF07 SS.V.F Soft stop time (CV mode) 0.0 (soft stop disabled)
CF08 ON.D Output-on delay setting 0.0 (no delay)
CF09 OFF.D Output-off delay setting 0.0 (no delay)
CF10 E.CC CC control using an external voltage/ external resistance OFF (control not used)
CF11 E.CV CV control using an external voltage/ external resistance OFF (control not used)
CF12 E.RNG CV/ CC control range LO (0 V to 5 V)
CF13
1
M.RNG Voltage/ Current monitor output range LO (0 V to 5 V)
CF14 E.OUT External control for turning output on/ off OFF (external control not used)
CF15 E.LOG External control logic for turning output on/off Turns on with LO (0 V to 5 V) or short
CF16 STS.C CC status signal polarity NEG (negative)
CF17 STS.V CV status signal polarity NEG (negative)
CF18 STS.O Output status signal polarity NEG (negative)
CF19 STS.A Protection function/ alarm status signal polarity NEG (negative)
CF20
1
A.RCV Output when AC-FAIL protection is released SAFE (output not automatically turned on)
CF21 WDOG Communication monitoring (WATCHDOG) timer OFF (timer off)
CF22 CC.LA Current setting limit ON (apply limit)
CF23 CV.LA Voltage setting limit ON (apply limit)
CF24
1
OC.DL Detection time of OCP activation 0.0 ms
CF30 SC1 CONFIG parameter shortcut registration (SC1) 00 (not registered)
CF31 SC2 CONFIG parameter shortcut registration (SC2) 00 (not registered)
CF32 SC3 CONFIG parameter shortcut registration (SC3) 00 (not registered)
CF33 BEEP Buzzer on/ off ON (Buzzer on)
CF34
1
BRI
Panel display brightness 7
CF35 AMTR Slave unit display during master-slave parallel operation OFF (not displayed)
CF40 LAN LAN interface setting ON (used)
CF41 USB USB interface setting ON (used)
CF42 232 RS232C interface setting ON (used)
CF43 TRAC SCPI communication error display OFF (not displayed)
CF44
1
PARA Master-slave parallel operation 1 (1 unit)
CF45 PON Output state at power-on SAFE (output off)
CF60 BOOT LAN setting reset/ apply LCI (LAN interface setting reset)
CF61 ADR IP address assignment method 110 (DHCP: On, AUTO IP: On, MANUAL IP: Off)
CF66 SUB IP address subnet mask 16
CF72 PID RS232C baud rate 19.2 (kbit/s)
CF80 PROG Program’s user code display (execute) NONE (not written)
CF83 TRG.I Trigger input signal polarity PTR (positive trigger)
CF84 TRG.O Trigger output signal polarity PTR (positive trigger)
1. You can also specify this parameter when the PWR-01 is being used as a slave unit.