Kikusui PWR401ML - About the J1; J2 Connectors

PWR-01 85
About the J1/ J2 Connectors
When the PWR-01 is shipped from the factory, terminal covers are
attached to the J1 and J2 connectors. Be sure to attach the cover
when you are not using the J1 or J2 connector. If the cover is dam-
aged or lost, contact your Kikusui agent or distributor.
The connector parts necessary to connect to the J1 and J2
connectors are not included. Use parts that match the connec-
tors to make the connections. The OP01-PWR-01 plug kit for
making these connections is available as an option. The plug
kit consists of connector parts made by WCON.
For information about how to obtain these tools or replace-
ment parts, contact your Kikusui agent or distributor.
 J1 and J2 connectors
Attaching a core
You need to attach a core to the cable that will be connected to the J1 connector (p.133).
The core is not included. Use an appropriate core.
Recommended core: E04SRS251512 by SEIWA ELECTRIC MFG. CO., LTD.
1
Unlock and open the core.
2
Wrap the cable once (two turns) around either half of
the open core.
Wrap the cable so that the distance between the core and the
J1 connector is within 30 mm.
3
Close the core making sure not to pinch the cable.
Check that the core is locked securely in place.
J1 connector J2 connector
Connector type WF2549-2WR10S3T01 (WCON) WF2549-2WR03S3T01(WCON)
Housing type WF2549-2H10W01 (WCON) WF2549-2H03W01 (WCON)
Terminal (pin) WF2549-TPS302 (WCON) WF2549-TPS302 (WCON)
Wire diameter
(core wire)
AWG20 to AWG24 AWG20 to AWG24
Manual pressure
welding tool
SN-28B (IWISS) or an equivalent
product
SN-28B (IWISS) or an equivalent
product
J1 connector J2 connector
OP01-PWR-01
[93420]
30 pin
pieces
Housing for the J1 connector
and J2 connector, 1 piece each
Unlock and open the
core.
To the J1
connector
PWR-01
J1 connector
Core
To the other end
Within
30 mm