PWR-01 29
Installation and Preparation ｜ Turning the Power On
Turning the POWER switch off
Turn the POWER switch off ( ).
The PWR-01 saves the panel settings (except the output on/off setting) that were in use
immediately before the POWER switch was turned off.
You can use the CONFIG settings (CF45) to select the output state of the PWR-01 when the
POWER switch is turned on (p.65).
If the POWER switch is turned off immediately after the settings have been changed, the last
settings may not be stored.
After you turn the POWER switch off, wait at least 10 seconds after the panel display turns
off before you turn the POWER switch back on. Repeatedly turning the POWER switch on
and off at short intervals can cause damage to the inrush current limiter. Furthermore, this
will shorten the service life of the POWER switch and the internal input fuse.
To Next Page
Loading...
