Krone Comprima F 155 XC - Compression Pressure Setting (COMPRIMA; Setting the Bale Diameter (COMPRIMA

V - 9
Basic Settings and Operation
5.4 Compression Pressure Setting
(COMPRIMA F 125; F 155)
Medium
Baling pressure is preselected using the adjusting
segment located behind the front right guard and is set
from inside the twine box via the wing nut on the right-
hand side.
Baling pressure preset:
• Manually raise the baling pressure indicators (1) to the
desired position (baling pressure).
• Loosen the wing nut (2) in the twine box and move the
bolt with wing nut in the slot until the control unit
indicator lights (filling) are on and the horn sounds.
• Tighten the fly nut inside the twine box.
RP-0-018
2
3
0
1
RP-A-035
1
2
RP-99-007
Never perform the baling pressure adjustment
with the system in automatic mode
5.4.1 Setting the Bale Diameter
(COMPRIMA F 155)
The bale diameter is set on the rear on the right and left
of the machine. The setting is made with the tailgate
closed.
To do this:
• Move the locking bolts (1) on the spring tube (3) on the
right and left of the machine and secure with cotter pin
(2).
Upper hole smallest bale diameter
Lower hole largest bale diameter
The locking bolts must always be set the
same on the right and left.
2
1
RPN00006_2
3