Krone Comprima F 155 XC - Hitching; Connecting the Hydraulic Hoses (COMPRIMA F 125; F 155)

III - 2
Before and After Use
Observe the maximum permissible support and hitching loads for the tractor!
Risk of hands and feet being pinched when the jack stand is actuated!
Hitch and secure the round baler to the tractor hitch in
accordance with specifications.
Set the jack stand in the transport position:
• Crank the support plate (3) upwards until pressure is
relieved on the jack stand (1).
• Remove stake bolt (2) and slide lower support pipe
upwards, securing it with the stake bolt (2).
• Turn the jack stand (1) to the upper position.
• Bring support chocks (4) into transport position.
3.2.1 Connecting the Hydraulic Hoses
(COMPRIMA F 125; F 155)
Two single-action control units are required on the tractor
to operate the machine.
Single-action control unit (1) (red1):
• Raise or lower tailgate
Single-action control unit (2) (red2):
The following functions of the control unit (2) depend on
the presetting on the control unit:
Single-action control unit (2) (yellow):
• Raise or lower pick-up or
• Raise or lower cutter tray
When connecting the hydraulic hoses,
make sure that the tractor and machine
hydraulics have been depressurized.
2
1
3
4
RPN00035
1
2
RBR01171_1
3.2 Hitching