BRAKES
37
FRONT BRAKE HOSE REPLACEMENT
When the front brake hose is leaking, cracked or worn you had
to replace it.
Please consider that there is no need to remove the brake calliper
when you need to replace the brake hose.
!
WARNING
Brake uid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of
children.
Wear suitable protective clothing and goggles.
If brake uid gets into your eyes, rinse thoroughly with water and
contact a doctor immediately.
Brake uid can damage paint, rubber and plastic parts. When
brake uid dripping on such parts wipe it away immediately.
1. Place a container under the brake calliper.
2. Remove the banjo bolt (1) and empty the brake hose (2).
3. Remove the banjo bolt (3) from the master brake cylinder.
4. Replace the brake hose. Take care that the brake hose is
installed correct and is connected to all brackets. Use new
gaskets when you connect the brake hose.
5. Remove the cover (4) with the membrane.
6. Add the recommended brake uid to the MAX level.
7. Open the bleed valve (5) and add a brake bleeding tool on
the valve. Start to aspirate the brake uid as long as air is in
the system. Take care that the brake uid level in the master
brake cylinder will not fall lower than the MIN level otherwise
you suck air in the system once again.
1. Suck continuously the air out of the system and add brake
uid continuously until the system has been bleeded.
9. Close the vent valve and rell the brake uid level to the MAX
level.
10. Reassemble all other parts in reverse order.
REAR BRAKE HOSE REPLACEMENT
When the rear brake hose is leaking, cracked or worn you must
replace it.
Please consider that there is no need to remove the brake calliper
when you need to replace the brake hose.
!
WARNING
Brake uid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of
children.
Wear suitable protective clothing and goggles.
If brake uid gets into your eyes, rinse thoroughly with water and
contact a doctor immediately.
Brake uid can damage paint, rubber and plastic parts. When
brake uid dripping on such parts wipe it away immediately.
1. Place a container under the brake calliper.
2. Remove the banjo bolt (1) and empty the brake hose (2).
1
2
5
3
4
1
2
5
To Next Page
Loading...
