BRAKE FLUID
!
WARNING
1. Never use dirty or unspecied brake uid or mix different
brake uids because it will damage the brake system.
2. Brake uid spilled on brake pads or brake disk will reduce the
braking effect. Clean the brake pads and brake disk with a
high quality brake degreaser.
3. When servicing the brake system, use shop towels to cover
plastic parts and coated surfaces to avoid damage caused by
splash of brake uid.
4. Do not allow dust or water to enter the brake system during
relling.
5. Brake uid should be replaced at least every 2 years.
SPECIFICATION
BRAKE HOSE
1. When the front/rear brake hose is leaking, cracked or worn
you had to replace it.
NOTE
Please consider that there is no need to remove the brake
calliper when you need to replace the brake hose.
2. When the brake hose need to be replaced use only genuine
parts.
3. For brake hose replacement see page 37.
FRONT/ REAR BRAKE PAD INSPECTION
Reduced braking efciency caused by worn brake pads.
Change worn brake pads immediately. Always replace the brake
pads in pair.
Front: See page 32
Rear: See page 33
BRAKES
99
Brake uid type
CASTROL SUPER DISK BRAKE FLUID DOT 4
Brake uid boiling temperature > 170°C
Brake uid water content < 3%
To Next Page
Loading...
