Kyocera FS-1030D

2G6
1-4-2
Service items Description
Software version: Software version:
Released: 7/Jun/2005Released: 7/Jun/2005
Controller firmware version*
Released date of the firmware
Service information
Service information
[EB20MA001/2G6_1000.001.010][22.00A][03/03] Total page 9690
/t/P00/S00/U00/F00/N00/
/0020/0020/1061/0811/ 0/ 0/ 0/ 0/ 0/ 0/ 0/ 0/ 0/
/RS2/1/1
A:1234567890123456
/03030303/03030303/03030303/03000000/00000000/03030303/03030303/
/03030303/03030303/03030303/03000000/00000000/03030303/03030303/
SPD1:0203040508090A0B0C0D0F101112131415161718191A1B1C1D1E1F202122235E
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
SN:SPL9200010
[EB20MA001/2G6_1000.001.010][22.00A][03/03] Total page 9690
/t/P00/S00/U00/F00/N00/
/0020/0020/1061/0811/ 0/ 0/ 0/ 0/ 0/ 0/ 0/ 0/ 0/
/RS2/1/1
A:1234567890123456
/03030303/03030303/03030303/03000000/00000000/03030303/03030303/
/03030303/03030303/03030303/03000000/00000000/03030303/03030303/
SPD1:0203040508090A0B0C0D0F101112131415161718191A1B1C1D1E1F202122235E
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
/8088808880808000/8088808880808000/8088808880808000/8088808880808000
SN:SPL9200010
Figure 1-4-1 Status page
Description
Prints a service status page for service purpose. The service status page includes various
printing settings and service cumulative.
Purpose
To acquire the current printing environmental parameters and cumulative information.
Procedure
To print a service status page, using the GO key on the operator panel. Or, have a PC
running MS-DOS and proceed as follows:
GO key
[Prints a user status page]
Press the GO key for 3 seconds or more and less than 10 seconds.
[Prints a service status page]
Press the GO key for 10 seconds or more.
PC
1. Connect the USB or parallel cable between printer and PC.
2. Turn printer power on. Make sure the printer is ready.
3. At the DOS prompt, send the following command to the printer:
echo !R! STAT1;EXIT;>prn
The service status page is printed. (If you omit "1" a user status page is printed.)
Printing a service
status page