109
6 Operating Control and Displays
6.3.1.4 First Connection with the Target Device
NOTICE
If you start the software without connected and available USB-CAN module you will receive
the following message:
Fig. 6-12 Message "No connection to LSB"
1. Install driver for USB-CAN module on the PC.
NOTICE
You may not connect the USB-CAN module to your computer while installing module driver!
2. Connect USB-CAN module to PC.
3. Start up of the software.
The software detects USB-CAN module automatically and creates a connection to the LSB.
Create connection manually or choose from several available modules
1. Connect CAN side of modules via LSB physically to end device.
2. Select options menu.
3. Select correct module in the USB-CAN (Systec) menu.
Fig. 6-13 USB-CAN menu
To Next Page
Loading...
