Lamtec BT300 BurnerTronic - Programming of Fuel;Air Ratio Control

128
6 Operating Control and Displays
6.3.5 Programming of Fuel/Air Ratio Control
1. Click on menu ’Curves (Fuel/Air ratio control)’.
Fig. 6-40 Curves window
2. Click on button ’Start EI-Mode (Setting)’.
3. Press OK to confirm the message ’Setting start’.
Automatic EI Mode is active now.
NOTICE
To use channel 4 set a continuously increasing curve!
NOTICE
Press OK during running time of the blue bar in the message.
Without activity during this period the process is aborted. An error message is issued.