96
6 Operating Control and Displays
6.3.1.2 Installing the Software
The LSB Remote Software visualises parameters and curve data of the target devices on
LAMTEC SYSTEM BUS (LSB). Values are edited and saved.
A USB-CAN module connects the target device via LSB. For this purpose, install the driver for
the USB-CAN module must be installed.
If connected via USB-CAN module, the current data for the target device can be retrieved.
Using specific dialogues, allows to take a targeted approach changing individual parameters,
deleting curves, or programming curve points.
The current status of the target device, which is determined by the settings of the parameters
and curve data, can be saved (back up) in a data set on the computer. Once backed-up, these
data sets can be restored later to reproduce a certain status in the BT300.
Refer to a schematic diagram in chapter 4.1 System Overview.
6.3.1.3 Installing the Software
Description of the Symbols
Click mouse button (left click)
Read
Fill out
Important
To Next Page
Loading...
