150
6 Operating Control and Displays
6.3.7.3 BurnerTronic
In menu path ’BurnerTronic’ it is possible to
• read parameters and edit their values (depending on access level)
• edit curves
• obtain fault history
• check status of inputs and outputs
• set single outputs with cold check (depending on access level)
• get information on device
Parameter
1. Find the description how to read or change parameters in chapter Edit Parameter.
Reading level CRCs
1. Click in menu on ’Parameters’ >> ’CRCs level’.
The window with CRC16 checksums of all level opens. The calculated parameters and the
parameters of the remote device are compared. Compare, if they both match.
Curve dialogue
1. Find a description of the curve dialogue in chapter 6.3.4.3 Setting Curves.
Check digital inputs
1. Click in menu on ’Input/Output’ >> ’Digital inputs’.
The window ’Digital inputs (BurnerTronic)’ opens.
The current state of digital inputs of the remote device are indicated.
Fig. 6-73 Menu ’BurnerTronic’
To Next Page
Loading...
