Lamtec BT300 BurnerTronic - 8.5.4.10 Bit Encoding: State of Actual Value of CO; 8.5.4.11 Bit Encoding: Cause of Fault of CO Controller

238
8 Options
Tab. 8-22 Bit encoding: State of flue gas temperature and efficiency
8.5.4.13 Bit Encoding: Status of Intake Air Temperature
Tab. 8-23 Bit encoding: Status of the intake air temperature
8.5.4.14 Encoding FAT State
Maintenance mode 0000 1000 0000 0000 0x0800
Sending the replacement value 0001 0000 0000 0000 0x1000
Warning of the measurement value 0010 0000 0000 0000 0x2000
Failure of the measurement value 0100 0000 0000 0000 0x4000
Measurement value is valid. 1000 0000 0000 0000 0x8000
Status Bit Pattern HEX Code
Status Bit Pattern HEX Code
Underflow 0000 0010 0000 0000 0x0200
Overflow 0000 0100 0000 0000 0x0400
Maintenance mode 0000 1000 0000 0000 0x0800
Sending a replacement value 0001 0000 0000 0000 0x1000
Measurement value warning 0010 0000 0000 0000 0x2000
Measurement value fault 0100 0000 0000 0000 0x4000
Measurement value is valid 1000 0000 0000 0000 0x8000
Description Value
Switched OFF 01
Permanent aeration is running 02
Stand-by 03
Pre-purge gas 05
Valve leakage check: Pre-purge 2 06
Valve leakage check: Pre-purge 1 07
Ignition point gas 08
Ignition transformer gas 09
Ignition: Pilot burner gas 10
Ignition: Safety time 1 for gas has expired 11
Ignition: Safety time 2 for gas is running 12
Base fire control for gas 13
Switch OFF gas valve 1 19
Switch OFF gas valve 2 20
Valve leakage check: Post-purge 2 Gas 21
Valve leakage check: Post-purge 1 Gas 22
Ignition without pilot burner gas: Safety time 2 is running 24
Ignition without pilot burner gas: Safety time 2 has expired 25
Maintenance mode gas 27
Pre-purge oil 29