7
1 Important Information about the Manual
1 Important Information about the Manual
1.1 Validity of these Instructions
This manual is valid for BT300 BurnerTronic
in any configuration.
The content of this document refers to software version BT300 v3.9 and UI300 V3.12 (HW V
1)/4.4 (HW V 2). Oth-er software versions may cause that some of the functions described in
this document are not available or have another functionality as described in this document.
1.2 Standards, Directives and Approvals
BT300 applies to the following standards and directives:
European Directives:
Harmonised European Standards:
USA and Canada:
NOTICE
To comply with the UL listed certificate BT300 + UI300 + LCM100 + VSM100 + DFM300 +
LEM100 must be installed in the same control cabinet.
The wiring in the control cabinet must be carried out according to the rules of NFPA70.
Australia:
2004/108/EU EMC Directive
2014/35/EU Low Voltage Directive
(EU)2016/426 Gas Appliance Directive
2014/68/EU Pressure Equipment Directive, Conformity Assessment cat. IV mod. B & D
2011/65/EU RoHS
EN 298
EN 13611
EN 1643 Integrated valve leakage check, gas line DIN DVGW PÜZ N6-2510 ASO 324
EN 12067-2
ISO 23552-1
EN 50156-1, no. 10,5
SIL 3 DIN EN 61508 part 1-7 (BT331, BT341)
MH48669 Controls, Primary Safety Certified for Canada - Component
UL 372
UL 1998
AGA AS 4625 - 2008
EN 298 - 2012
To Next Page
Loading...
Need help?
General
