Lamtec BT300 BurnerTronic - 6.1.7.7 User Interface Settings

88
6 Operating Control and Displays
PID Controller Settings
•Mode
• Speed
• Physical units
CO/O
2
Controller Settings
•ON/OFF
•Correction mask
• Correction spreading
O
2
Trim Settings
• Correction range
• Testing O
2
trim
•O
2
curve settings
• Delete O
2
setpoint curve or optimisation curve
• Adjusting P term and dead time
• Adjusting the activer range of the O
2
trim
CO Controller Settings
• CO controller settings
• Correction range
• Testing CO correction
• CO edge
• Adjusting the activer range of the CO controller
• Deliting CO optimisation curve
• Si-CarboSen configuration