Figure 21. Connectors on the backplane for four 3.5-inch SAS/SATA drives
1 SAS connector
2 Power connector
For power cable connection, see “Power/Sideband cable routing” on page 28.
Refer to the following cable routing for different configurations:
• “Four 3.5-inch SATA drives” on page 32
• “Four 3.5-inch SAS/SATA drives and one 8i RAID adapter” on page 33
• “Four 3.5-inch SATA drives and rear SAS/SATA drive assembly” on page 34
• “Four 3.5-inch SAS/SATA drives, rear SAS/SATA drive assembly and one 8i RAID adapter” on page 35
• “Four 3.5-inch SATA drives and rear NVMe drive assembly” on page 36
• “Four 3.5-inch SAS/SATA drives, rear NVMe drive assembly and one 8i RAID adapter” on page 37
• “Four 3.5-inch SATA drives and middle drive cage” on page 38
• “Four 3.5-inch SAS/SATA drives, middle drive cage and one 8i RAID adapter” on page 39
Chapter 2. Server components 31
To Next Page
Loading...
