Lenze i750 - The Concept

The concept
The i750 servo inverter is a mul-a
xis inverter, i.e. the axes are interconnected via an
integrated DC bus. The supplier connected to the AC system feeds the DC bus.
A controller programmed according to IEC 61131 controls the axes via the CiA 402 device
prole.
The Lenze engineering tool "PLC Designer" is available for programming the controller. The
FAST funcon library enables the rapid creaon of applicaons.
EtherCAT® is used for real-me communicaon.
Required components for a basic i750 system
For a basic system for central moon control you need these components:
•
A c
ontroller
-
e.g. c550 controller
-
More informaon on the product page
•
i750 axes
-
Data for mains voltage 400 V 4Axes data ^ 82
-
Data for mains voltage 480 V 4Axes data ^ 90
•
A supplier for the axes
-
Data for mains voltage 400 V 4Power supply data ^ 79
-
Data for mains voltage 480 V 4Power supply data ^ 87
•
Servo motors for the applicaon
-
e.g MCS synchronous servo motors
-
More informaon on the product page
•
System cables
-
e.g. for connecng motors
-
Data for system cables 4System cables ^ 171
•
The Lenze Engineering Tool »PLC Designer«
-
Download »PLC Designer«
•
A Windows® PC
•
Addionally when using a product variant with Extended Safety
-
A c250-S safety controller
-
More informaon on the product page
i700/i750 tutorials are available for easy commissioning.
i700 ser
vo inverter - Start-up tutorials
Product in
formaon
Product descripon
The concept
12