Lenze i750 - Approved Manufacturers for BCP Fusing

Short Circuit Current Rangs (SCCR) with Semic
onductor Fuses
(Tested per UL61800-5-1, reference UL le E132659)
These devices are suitable for standard installaon when used with Semiconductor Fuses. For
single motor installaon, if the fuse value indicated is higher than 400 % of the motor current
(FLA), the fuse value has to be calculated. If the value of the fuse is below two standard
rangs, the nearest standard rangs less than the calculated value shall apply.
Supplier Alternate Fuse (Semiconductor Fuse)
Max. SCCR Max. rated current
kA A
E70ACPSE0304
E70ACPSE0604
Approved manufacturers for BCP fusing
Electrical ins
tallaon
Connecon according to UL
Fusing data
57