Installation Guide
you want. On the next window sign the Create shortcut on desktop
checkbox, then click on Next! After you've read the installation summery,
click on Install! After the installation has finished, restart your computer!
• Connect the Local Network Switch to your computer and run the
SCPlayer by clicking on the desktop icon! Adjust the IP address of the
camera in the pop up window! The camera picture is going to be shown
immediately on the video monitor surface of the software. If the picture
is upside down, it can be rotated by pressing R.
• Several SCPlayer software can be run simultaneously. Open two more
SCPlayer software! Visualize neighboring camera pictures in each video
matrix window! Arrange the windows on the desktop in one common
line according to the physical camera order! The essence of this method
is to see the camera pictures relative to each other.
• Set the direction and the angle of each camera. You can find the virtual
view of each camera in the previously designed digital plan. These
pictures help you to find the right and final position of each camera. Use
clearly visible objects at the seats at image overlapping areas to find
easily the right position! First move the camera with the camera
enclosure and find the approximately right position, than fine-tune the
position by setting the position fine-tuning panel in the camera
enclosure! To set the panel, follow the steps below:
10/80
To Next Page
Loading...