Installation Guide
Control Center software!
3. The previously created Monitor Profile with the Panorama camera
appears on the left as a button with its name. Click on it! Now the
camera pictures are shown in the Video monitor.
4. Once the connection is established, the pictures of the IP cameras which
are in the common camera group can be seen side by side. To see an
appropriate panorama picture you have to stitch the camera pictures so
as overlapping the pictures by designating common points.
5. Press F2 button!
6. Zoom in the camera pictures at the image borders!
7. If you move your mouse over the border of two cameras, a blue
rectangle will be shown. This indicates the cameras which you are going
to stitch. As you move your mouse to the following camera, the next
rectangle will be highlighted. You can lock the selection by pressing and
holding the Shift key.
8. Find common points and select them on both images by Shift+left
mouse button! Common points are signed by the same color markers.
Repeat this step a few times at the border of the images! The markers
should be approximately in a straight vertical line in the image. There
should be one marker close to the top image border if possible, and one
close to the bottom image border.
63/80
To Next Page
Loading...