LPKF ProtoMat S63 - Protomat S63

Product description ProtoMat S
16 HB V0.9/Mrz-11 © 2011 LPKF AG
1
1.5.2 ProtoMat S63
EC declaration of conformity in accordance with machinery directive 2006/42/EG,
Appendix II A
The manufacturer/seller
LPKF Laser & Electronics AG
Osteriede 7
30827 Garbsen
Germany
hereby declares that the following product
Product name LPKF ProtoMat S63
Product type: Mill/drill plotter
conforms to the provisions of the directive identified above – including the
modifications effective at the time of this declaration.
This declaration refers to the product status where the product was placed on
the market. Parts or modifications installed afterwards by the operator are not
taken into consideration. Any subsequent modification shall invalidate the
declaration for this product.
The following harmonized standards are applied:
EN 60204-1:2007 Safety of machinery - Electrical equipment of
machines - Part 1: General requirements
The following domestic and international standards (or parts/clauses of this
standards) and specifications are applied:
EN ISO 12100-2:2004 Safety of machinery - Basic concepts,
general principles for design - Part 2:
Technical principles
EN ISO 12100-1:2004 Safety of machinery - Basic concepts,
general principles for design - Part 1: Basic
terminology, methodology
EN ISO 14121-1:2007 Safety of machinery - Risk assessment -
Part 1: Principles (ISO 14121-1:2007)
We maintain a quality assurance system according to DIN EN ISO 9001 that
has been certified by DeuZert - Certification number: A 40583 22 00 1.
Person authorized to compile the documentation: Rainer Aschenbeck
Address of the person: see manufacturer address