LPKF ProtoMat S63 - User Manual

Questions and Answers

T
Timothy FrostAug 8, 2025
Why LPKF Plotter has no connection?
- T
  trogersAug 8, 2025
  The LPKF Plotter might not be connecting due to several reasons: * There may be no power supply. Ensure the mains cable is correctly connected and plugged into the socket. * The main switch of the circuit board plotter might be in the OFF position. Set the switch to ON. * There could be a data transmission problem. Inspect the USB cable between the plotter and PC, ensuring it is properly connected or replace it. * The USB settings of the operating system might need to be checked.
D
david39Aug 19, 2025
What to do if LPKF Plotter has no dust extraction?
- L
  Linda FosterAug 19, 2025
  If the LPKF Plotter's dust extraction isn't working, consider the following: * Verify the power supply by checking the mains cable and plugging it into the socket if needed. * Ensure the main switch of the dust extraction is set to either ON or AUTOMATIK. * Check if a fuse has triggered, and if so, press the Reset Button on the dust extraction. * Examine the USB cable between the circuit board plotter and dust extraction, ensuring it's properly connected or replace it.
J
James RobertsAug 28, 2025
How to fix an uptight tool in LPKF Plotter?
- K
  Kelsey BondAug 28, 2025
  If a tool is uptight in your LPKF Plotter, it might be due to: * An incorrect tool holder position. You should import the tool holder position again. * Improper tool insertion. Make sure to insert the tool with its top down into the tool holder until it stops. * A soiled tool holder. Clean the tool holder. * A soiled collet chuck. Clean the collet chuck.