V. 1.0 | LPKF Laser & Electronics AG
Improper use
Only control the system with the system software that is included in the scope of
delivery.
The system may only be operated with an extraction system that is sufficiently
dimensioned.
Contact the LPKF sales department or your local representative if you plan to use
another extraction system.
Only use qualified and approved extraction systems.
Any other kind of use is considered as not intended . The manufacturer is not liable for
any damage resulting from this, the operator alone bears the risk. Part of the intended
use is also to follow the instructions for safety in this user manual with regard to
operation and maintenance of the system.
The system must not be used for processing highly combustible materials like e.g.
paper or wood, sealed containers, hollow parts, textiles, or food.
Do not use the system with a different or modified software.
1.2 Residual risks
No residual risks have currently been identified, if the intended use as well as all
safety regulations are observed. Any identified residual risks and their avoidance are
listed in the form of safety instructions starting in chapter 1.3. Non-observance can
cause personal injuries and property damage.
1.3 Basic hazards
Always comply with the warning messages listed here and in the individual sections of
this documentation to reduce the risks of injuries and property damage and to avoid
dangerous situations.
1.3.1 Mechanical hazards
Risk of injury by moving components!
Moving components can cause serious injuries e.g. crushing injuries or cuts.
Never grasp moving components when the system is operating.
Observe the follow-up time of the spindle. Before doing any work in the
processing area or on the processing head, ensure that no component is still
moving.
Risk of injuries by pressurized components!
Pressurized components (e.g. compressed-air supply) can move uncontrollably in
case of improper handling or in case of a defect and can cause serious injuries.
Depressurize the components before working on them. De-energize the
residual energies.
Always ensure that there is no unintended escape of compressed air.
Defective components that are under pressure when operating the system have
to be replaced immediately by sufficiently qualified personnel.
To Next Page
Loading...
