Danger to life by electrical shock!
Touching energized parts causes a direct danger to life by electrical shock. Damage
to the insulation or damaged individual parts can be dangerous to life.
Use only the mains cable included in the delivery or a mains cable approved by
LPKF.
All work on energized components of the system must be performed by a
qualified electrician.
If the insulation is damaged, switch off the power supply immediately and
initiate the repair.
De-energize all energized components of the system or equipment, before
working with them. Ensure that the system or equipment is de-energized for the
whole time of the task.
Never bridge or deactivate fuses.
Always keep moisture away from energized parts because it can cause a short
circuit.
Burn hazard by hot surfaces!
During processing, some system components can heat up so much that direct
contact can cause burns.
Always wear your personal protective equipment.
Health hazard by faulty extraction!
When processing materials, gases or dusts hazardous to health can be produced.
Ensure that the extraction system is switched on and is working properly.
Observe the maintenance intervals of the extraction system.
Check the connection to the system regularly.
To Next Page
Loading...
