V. 1.0 | LPKF Laser & Electronics AG
4 Transport and storage
This chapter contains important information on transport, packaging and storage of the
system.
Risk of injury by improper transport!
Incorrect transport using the enclosed lifting device can cause serious injuries. The
lifting device serves only for lifting and putting down the system.
Transport the system only with a sufficiently load-bearing means of transport.
Risk of injury by heavy load!
The system is heavy and bulky and must not be lifted by one person. Incorrect lifting
can cause serious injuries, e.g. crushing injuries or spinal injuries.
Always lift the system with four persons using the enclosed lifting device.
Always wear the recommended safety shoes and protective gloves.
System damage by improper transport!
Improper transport can cause damage to the system.
Transport the system cautiously to the place of installation.
Observe the symbols on the packages.
Remove the packaging only directly before system installation.
Damage by empty collet!
The collet always has to be equipped with a tool even when the system is not in use
(standby, switched off, transport, storage).
Ensure that a tool is in the collet or a tool is in the tool magazine where it can be
picked up by the collet.
To Next Page
Loading...
